Makita LF1000 User Manual download pdf (Page 20)

P 20/ 30

Repair

[4] ADJUSTMENT

[4] -1. Adjusting Bevel Angle

Fig. 52 Fig. 53

Fig. 54 Fig. 55

1) Lock the saw head unit in the full down position, and loosen Lever 100. Then rotate the 90 degree adjusting screw

two or three turns counterclockwise using Hex wrench 3, and tilt the blade to the right. (Fig. 52)

2) Put 90 degree set square (No.1R208) on the top surface of Turn table and beside the blade. Turn the 0 degree

adjusting screw carefully clockwise until No.1R208 closely contacts the blade without gap between their surfaces

and between the surfaces of No.208 and Turn table. Then tighten Lever 100. (Fig. 53)

3) After performing this adjustment, make sure that the pointer of Indication plate is indicating 0 degree on Bevel scale.

If not, loosen the screw that fastens Indication plate and adjust the pointer to 0 degree.

[Bottom of Table viewed from the Lever 100 installation side] [Table and Blade viewed from

the Lever 100 installation side]

[Bottom of Table viewed from the Lever 100 installation side]

[Table and Blade viewed from

the Lever 100 installation side]

0 degree adjusting screw 45 degree adjusting screw

No.1R207

Lever 100

Saw head unit

Important: Before performing 45 degree bevel angle adjustment, be sure to do 0 degree bevel angle adjustment.

1) Tilt the saw head unit fully to the right. (Fig. 54)

2) Put 45 degree set square (No.1R207) on the top surface of Turn table and beside the blade. Turn the 45 degree

adjusting screw carefully clockwise until No.1R207 closely contacts the blade without gap between their surfaces

and between the surfaces of No.207 and Turn table. Then tighten Lever 100. (Fig. 55)

3) After performing this adjustment, make sure that the pointer of Indication plate is indicating 45 degrees on Bevel

scale. If not, loosen the screw that fastens Indication plate and adjust the pointer to 45 degrees.

0 Degree Bevel

45 Degree Bevel

[right][left]

No.1R208

Saw blade

Turn table

[right][left]

Saw blade

Turn table

1 ... 19 20 21 ... 30

No comments

Makita LF1000 User Manual Page 20