Makita GA9020S Instruction Manual download pdf (Page 9)

• When using an abrasive cut-off / diamond wheel,

be sure to use only the special wheel guard

designed for use with cut-off wheels. (In some

European countries, when using a diamond wheel,

the ordinary guard can be used. Follow the

regulations in your country.)

For tool with locking screw type wheel guard

006736

Mount the wheel guard with the protrusion on the wheel

guard band aligned with the notch on the bearing box.

Then rotate the wheel guard to such an angle that it can

protect the operator according to work. Be sure to

tighten the screw securely.

To remove wheel guard, follow the installation

procedure in reverse.

For tool with clamp lever type wheel guard

010644

010645

Loosen the lever on the wheel guard. Mount the wheel

guard with the protrusion on the wheel guard band

aligned with the notch on the bearing box. Then rotate

the wheel guard around to the position shown in the

figure. Tighten the lever to fasten the wheel guard. If the

lever is too tight or too loose to fasten the wheel guard,

loosen or tighten the nut by spanner to adjust the

tightening of the wheel guard band.

To remove wheel guard, follow the installation

procedure in reverse.

Installing or removing depressed center

grinding wheel/Multi-disc (accessory)

006746

Mount the inner flange onto the spindle. Fit the

wheel/disc on the inner flange and screw the lock nut

onto the spindle.

To tighten the lock nut, press the shaft lock firmly so that

the spindle cannot revolve, then use the lock nut wrench

and securely tighten clockwise.

006738

To remove the wheel, follow the installation procedure in

reverse.

Super flange

Models GA7020F,GA7020SF,GA9020F and GA9020SF

are standard-equipped with a super flange. Only 1/3 of

efforts needed to undo lock nut, compared with

conventional type.

NOTE:

• Only for tools with M14 spindle thread

Installing or removing abrasive disc

(optional accessory)

NOTE:

• Use sander accessories specified in this manual.

These must be purchased separately.

010948

1. Lock nut

2. Abrasive disc

3. Rubber pad

1. Lock nut wrench

2. Shaft lock

1. Lock nut

2. Depressed

center wheel

3. Super flange

4. Inner flange

1. Nut

2. Lever

1. Wheel guard

2. Bearing box

3. Nut

4. Lever

1. Wheel guard

2. Screw

3. Bearing box

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Makita GA9020S Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Straight grinders Makita GA9020S