Makita 9566PCV Instruction Manual download pdf (Page 8)

returns to admissible levels, the tool will operate as

normal.

Soft start feature

• Soft start because of suppressed starting shock.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Installing side grip (handle)

008373

CAUTION:

• Always be sure that the side grip is installed

securely before operation.

Screw the side grip securely on the position of the tool

as shown in the figure.

Installing or removing wheel guard

CAUTION:

• The wheel guard must be fitted on the tool so that

the closed side of the guard always points toward

the operator.

For tool with locking screw type wheel guard

008374

Mount the wheel guard with the protrusion on the wheel

guard band aligned with the notch on the bearing box.

Then rotate the wheel guard around 180 degrees

counterclockwise. Be sure to tighten the screw securely.

To remove wheel guard, follow the installation procedure

in reverse.

For tool with clamp lever type wheel guard

008375

008376

Pull the lever in the direction of the arrow after loosening

the screw. Mount the wheel guard with the protrusion on

the wheel guard band aligned with the notch on the

bearing box. Then rotate the wheel guard around 180°.

Fasten it with the screw after pulling lever in the direction

of the arrow for the working purpose. The setting angle

of the wheel guard can be adjusted with the lever.

To remove wheel guard, follow the installation procedure

in reverse.

Installing or removing depressed center

grinding wheel/Multi-disc (accessory)

Mount the inner flange onto the spindle. Fit the

wheel/disc on the inner flange and screw the lock nut

onto the spindle.

008377

To tighten the lock nut, press the shaft lock firmly so that

the spindle cannot revolve, then use the lock nut wrench

and securely tighten clockwise.To remove the wheel,

follow the installation procedure in reverse.

1. Lock nut

2. Depressed

center grinding

wheel/Multi-disc

3. Inner flange

1. Screw

1. Wheel guard

2. Bearing box

3. Screw

4. Lever

1. Wheel guard

2. Bearing box

3. Screw

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita 9566PCV Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Straight grinders Makita 9566PCV