Makita HM1203C Instruction Manual download pdf (Page 7)

009944

The bit can be secured at 12 different angles. To change

the bit angle, slide the change ring forward, then turn the

change ring to change the bit angle. At the desired angle,

slide the change ring back to the original position. The

bit will be secured in place.

NOTE:

• The change ring cannot turn when the bit is not

installed on the tool.

OPERATION

Chipping/Scaling/Demolition

009948

Always use the side grip (auxiliary handle) and firmly

hold the tool by both side grip and switch handle during

operations. Turn the tool on and apply slight pressure on

the tool so that the tool will not bounce around,

uncontrolled. Pressing very hard on the tool will not

increase the efficiency.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection

or maintenance.

• Never use gasoline, benzine, thinner, alcohol or

the like. Discoloration, deformation or cracks may

result.

Lubrication

CAUTION:

• This servicing should be performed by Makita

Authorized or Factory Service Centers only.

This tool requires no hourly or daily lubrication because

it has a grease-packed lubrication system. However, it is

recommended to periodically replace the grease for

longer tool life.

Run the tool for several minutes to warm it up. Switch off

and unplug the tool.

Loosen the six screws and remove the handle. Note that

the top screws are different from other screws.

009951

Disconnect the connector by pulling them.

009950

Loosen the four screws on crank cap and remove the

crank cap cover.

009952

Wipe out the old grease inside and replace with a fresh

grease (60 g). Use only Makita genuine hammer grease

(optional accessory). Filling with more than the specified

amount of grease (approx. 60 g) can cause faulty

hammering action or tool failure. Fill only with the

specified amount of grease.

1. Screwdriver

2. Crank cap cover

1. Connector

2. White

3. Black

1. Screws

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HM1203C Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Makita HM1203C