Makita HM1203C Instruction Manual download pdf (Page 5)

10. Keep hands away from moving parts.

11. Do not leave the tool running. Operate the tool

only when hand-held.

12. Do not point the tool at any one in the area

when operating. The bit could fly out and

injure someone seriously.

13. Do not touch the bit or parts close to the bit

immediately after operation; they may be

extremely hot and could burn your skin.

14. Do not operate the tool at no-load

unnecessarily.

15. Some material contains chemicals which may

be toxic. Take caution to prevent dust

inhalation and skin contact. Follow material

supplier safety data.

SAVE THESE INSTRUCTIONS.

WARNING:

MISUSE or failure to follow the safety rules stated in

this instruction manual may cause serious personal

injury.

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and

unplugged before adjusting or checking function on

the tool.

Switch action

OFF

009947

CAUTION:

• Before plugging in the tool, always check to see

that the tool is switched off.

• Switch can be locked in "ON" position for ease of

operator comfort during extended use. Apply

caution when locking tool in "ON" position and

maintain firm grasp on tool.

To start the tool, push the switch lever "ON (I)" on the left

side of the tool. To stop the tool, push the switch lever

"OFF (O)" on the right side of the tool.

Speed change

009955

The blows per minute can be adjusted just by turning the

adjusting dial. This can be done even while the tool is

running. The dial is marked 1 (lowest speed) to 5 (full

speed).

Refer to the table below for the relationship between the

number settings on the adjusting dial and the blows per

minute.

Number on adjusting dial Blows per minute

1,900

1,700

1,450

1,200

950

009956

CAUTION:

• The speed adjusting dial can be turned only as far

as 5 and back to 1. Do not force it past 5 or 1, or

the speed adjusting function may no longer work.

For Model HM1213C only

NOTE:

• Blows at no load per minute becomes smaller than

those on load in order to reduce vibration under no

load, but this does not show trouble. Once

operation starts with a bit against concrete, blows

per minute increase and get to the numbers as

shown in the table. When temperature is low and

there is less fluidity in grease, the tool may not

have this function even with the motor rotating.

Indicator lamp

009949

1. Power-ON

indicator lamp

(green)

2. Service indicato

lamp (red)

1. Adjusting dial

1. Switch lever

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HM1203C Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Makita HM1203C