Makita G4300L Owner's Manual download pdf (Page 12)

5. GROUNDING THE GENERATOR

4. CHECK GENERATOR SURROUNDINGS.

Make sure you review each warning in

order to prevent fire hazard.

■■

Keep area clear of in flammables or

other hazardous materials.

■■

Keep generator at least 3 feet (1 meter)

away from buildings or other structures.

■■

Only operate generator in a dry, well

ventilated area.

■■

Keep exhaust pipe clear of foreign

objects.

■■

Keep generator away from open flame.

No smoking!

■■

Keep generator on a stable and level

surface.

■■

Do not block generator air vents with

paper or other material.

WARNING

OPERATING PROCEDURES

(See Fig.

)

1. STARTING THE GENERATOR

■■

To ground the generator to the earth, connect

the grounding lug of the generator to the

grounding spike driven into the earth or to the

conductor which has been already grounded

to the earth. (See Fig. 2-t)

q GROUNDING SPIKE

■■

If such grounding conductor or grounding

electrode is unavailable, connect the

grounding lug of the generator to the

grounding terminal of the using electric tool or

appliance. (See Fig. 2-y)

q GROUND TERMINAL

Check the oil level before each operations

as outlined on page 5.

CAUTION

(a) Make sure the appliance is disconnected.

(b)Turn engine switch to " "(CHOKE) position.

(When engine is warm or temperature is high,

start engine with the switch at " " (RUN)

position.) (See Fig. 3-q)

q "" (STOP) w "" (CHOKE)

compression point (resistance will be felt), then

return the handle to its original position and pull

briskly. (See Fig. 3-w)

q RECOIL STARTER HANDLE

w PULL BRISKLY

(d)After starting, allow the starter handle to return to

its original position with the handle still in your hand.

■■

Do not connect defective appliances

including lines and plugs.

■■

Be sure appliances are not connected

to generator when starting up.

Starting the generator with an

appliance connected could result in

damage to the generator and/or

appliance and in personal injury.

CAUTION

NOTE

When engine fails to start after several attempts,

repeat the starting procedures mentioned above with

the engine switch placed at " " (RUN) position.

(e) After 20 to 30 seconds of warm-up is completed,

turn the engine switch to " " (RUN) position.

(See Fig. 3-e)

q "" (CHOKE) w "" (RUN)

(f) Make sure the pilot lamp is on.

This indicates that the generator is properly

operating.

NOTE

■■

If the pilot lamp is off, Set the AC breaker

to "ON" position.

■■

If no generating condition is found out,

please consult nearest Makita factory or

authorized service center.

G2800L(US)_GU1843 2004.2.6 1:14 PM ページ6

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Makita G4300L Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Power generators Makita G4300L