Makita LS1045 Instruction Manual download pdf (Page 5)

VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,

outlet, etc.) be sure the voltage supplied is the same as

that

specified

the

nameplate of the tool. A power source with voltage greater than that specified

for the tool can result

SERIOUS INJURY to the user

as well as damage to

the tool.

doubt, DO NOT PLUG IN

THE

TOOL. Using a power source with

voltage less than the nameplate rating is harmful to the motor.

ADDITIONAL SAFETY RULES

Wear eye protection.

not operate saw without guards

place.

Don't use the tool

the presence of flammable liquids or gases.

Check the blade carefully for cracks or damage before operation.

Use only flanges specified for this tool.

Be careful not to damage the arbor, flanges (especially the installing surface)

Make sure that the turn base is properly secured

will

not move during

For your safety, remove the chips, small pieces, etc. from the table top before

Avoid cutting nails. Inspect for and remove all nails from the workpiece before

Replace cracked or damaged blade immediately.

or bolt. Damage to these parts could result in blade breakage.

operation.

IO.

Make sure the shaft lock is released before the switch is turned

on.

11.

Be sure that the blade does not contact the turn base in the lowest position.

12.

Hold the handle firmly. Be aware that the saw moves up or down slightly

during start-up and stopping.

13.

Do not perform any operation freehand. The workpiece must be secured

firmly against the turn base and guide fence during all operations.

14.

Keep hands out of path of saw blade. Avoid contact with any coasting blade.

can still cause severe injury.

15.

Never reach around saw blade.

16.

Make sure the blade is not contacting the workpiece before the switch is

turned on.

17.

Before using the tool on an actual workpiece, let

run for a while. Watch

for vibration or wobbling that could indicate poor installation or a poorly

balanced blade.

18.

Wait until the blade attains full speed before cutting.

19.

Stop operation immediately

you notice anything abnormal.

20.

Do not attempt to lock the trigger in the on position.

1 2 3 4 5 6 7 8 9 10 ... 26 27

Comments to this Manuals

No comments

Makita LS1045 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1045