Makita LS1045 Instruction Manual download pdf (Page 19)

MAINTENANCE

CAUTIO N:

Always be sure that the tool is switched off and unplugged before attempting to perform

inspection or maintenance.

WARNING:

Always be sure that the blade is sharp and clean for the best and safest performance

Alignment

for

squareness

This tool was carefully adjusted and aligned for squareness of cut

the factory, but rough

handling may have affected the alignment. If your tool is not aligned properly, perform the

following.

Miter angle

Loosen the grip and set the turn base at zero degrees

turning the turn base. Tighten

the grip securely and loosen the hex bolts on the guide fence. Square the side of the

blade with the face of the guide fence using

triangular rule, try-square, etc. by moving

the right side of the guide fence. Then securely tighten the hex bolts on the guide fence

in the order indicated in the figure.

Hex.

bolt

Bevel angle

bevel angle

Loosen the lever at the rear

the

tool. Loosen the hex nut and turn the

hex bolt (A) two or three revolutions

clockwise

that the blade tilts to

the right.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

No comments

Makita LS1045 Instruction Manual Page 19