Makita LS1013L Instruction Manual download pdf (Page 9)

Aligning the laser line

Laser line can be shifted to either the left or right side of

the blade according to the applications of cutting. Refer

to explanation titled “Laser beam action” regarding its

shifting method.

NOTE:

• Use wood facing against the guide fence when

aligning the cutting line with the laser line at the

side of guide fence in compound cutting (bevel

angle 45 degrees and miter angle right 45

degrees).

A) When you obtain correct size on the left side of work-

piece

• Shift the laser line to the left of the blade.

B) When you obtain correct size on the right side of work-

piece

• Shift the laser line to the right of the blade.

Align the cutting line on your workpiece with the laser

line.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Socket wrench storage

The socket wrench is stored as shown in the figure.

When using the socket wrench, pull it out of the wrench

holder. After using the socket wrench, return it to the

wrench holder.

Installing or removing saw blade

CAUTION:

• Always be sure that the tool is switched off and

unplugged before installing or removing the blade.

• Use only the Makita socket wrench provided to

install or remove the blade. Failure to do so may

result in overtightening or insufficient tightening of

the hex bolt. This could cause an injury.

Lock the handle in the raised position by pushing in the

stopper pin.

To remove the blade, use the socket wrench to loosen

the hex bolt holding the center cover by turning it coun-

terclockwise. Raise the blade guard and center cover.

Press the shaft lock to lock the spindle and use the

socket wrench to loosen the hex bolt clockwise. Then

remove the hex bolt, outer flange and blade.

To install the blade, mount it carefully onto the spindle,

making sure that the direction of the arrow on the surface

of the blade matches the direction of the arrow on the

blade case.

Install the outer flange and hex bolt, and then use the

socket wrench to tighten the hex bolt (left-handed)

securely counterclockwise while pressing the shaft lock.

1. Socket wrench

2. Wrench holder

006341

001530

1. Stopper pin

1. Center cover

2. Hex bolt

3. Socket wrench

4. Blade guard

1. Blade case

2. Arrow

3. Shaft lock

4. Hex bolt

5. Socket wrench

001564

001532

001533

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 71 72

Comments to this Manuals

No comments

Makita LS1013L Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1013L