Makita LS1013L Instruction Manual download pdf (Page 11)

CAUTION:

• When performing left bevel cuts, flip the fence over

to the left position as shown in the figure.

Otherwise, it will contact the blade or a part of the

tool, causing possible serious injury to the operator.

Sub-fence R (optional accessory)

The sub-fence R can be installed on the right side of the

guide fence. Insert the rods of the sub-fence R into the

holes in the guide fence. Tighten the screws which come

with the sub-fence R to secure the sub-fence R.

CAUTION:

• When performing right bevel cuts, never use the

sub-fence R. It will contact the blade or a part of the

tool, causing possible serious injury to the operator.

Vertical vise

The vertical vise can be installed in two positions on

either the left or right side of the guide fence or the base.

Insert the vise rod into the hole in the guide fence or the

base and tighten the screw on the back of the guide

fence to secure the vise rod.

Position the vise arm according to the thickness and

shape of the workpiece and secure the vise arm by tight-

ening the screw. If the screw to secure the vise arm con-

tacts the guide fence, install the screw on the opposite

side of vise arm. Make sure that no part of the tool con-

tacts the vise when lowering the handle fully and pulling

or pushing the carriage all the way. If some part contacts

the vise, re-position the vise.

Press the workpiece flat against the guide fence and the

turn base. Position the workpiece at the desired cutting

position and secure it firmly by tightening the vise knob.

CAUTION:

• The workpiece must be secured firmly against the

turn base and guide fence with the vise during all

operations.

Horizontal vise (optional accessory)

The horizontal vise can be installed in two positions on

either the left or right side of the base. When performing

15° or greater miter cuts, install the horizontal vise on the

side opposite the direction in which the turn base is to be

turned.

By flipping the vise nut to the left, the vise is released,

and rapidly moves in and out. To grip the workpiece,

push the vise knob forward until the vise plate contacts

the workpiece and flip the vise nut to the right. Then turn

the vise knob clockwise to secure the workpiece.

The maximum width of workpiece which can be secured

by the horizontal vise is 200 mm (7-7/8”).

When installing the horizontal vise on the right side of the

base, also use the sub-fence R to secure the workpiece

more firmly. Refer to the “Sub-fence R” section described

on previously for installing the sub-fence R.

CAUTION:

• Always rotate the vise nut to the right fully when

securing the workpiece. Failure to do so may result

in insufficient securing of the workpiece. This could

cause the workpiece to be thrown, cause damage

1. Sub-fence

1. Sub-fence R

2. Screws

1. Vise arm

2. Vise rod

3. Screw

4. Vise knob

5. Guide fence

001546

001547

001548

1. Vise plate

2. Vise nut

3. Vise knob

2 3

001550

005232

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 71 72

Comments to this Manuals

No comments

Makita LS1013L Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1013L