Makita LS0815FL Instruction Manual download pdf (Page 12)

001549

Guide fence (SLIDING FENCES) adjustment

014278

CAUTION:

• Before operating the tool, make sure that the

sliding fence is secured firmly.

• Before bevel-cutting, make sure that no part of

the tool, contacts the sliding fence. when fully

lowering and raising the handle in any position

and while moving the carriage through its full

range of travel.

010407

CAUTION:

• When performing bevel cuts, slide the sliding

fence to the left and secure it as shown in the

figure.

This tool is equipped with the sliding fence which should

ordinarily be positioned as shown in the figure.

However, when performing left bevel cuts, set it to the

left position as shown in the figure if the tool head

contacts it.

When bevel-cutting operations are complete, don't

forget to return the sliding fence to the original position

and secure it by firmly tightening the clamping screw.

Vertical vise

1 2

014289

The vertical vise can be installed on either the left or

right side of the guide fence. Insert the vise rod into the

hole in the guide fence and tighten the screw on the

back of the guide fence to secure the vise rod.

Position the vise arm according to the thickness and shape of

the workpiece and secure the vise arm by tightening the screw.

If the screw to secure the vise arm contacts the guide fence,

install the screw on the opposite side of vise arm. Make sure

that no part of the tool contacts the vise when lowering the

handle fully and pulling or pushing the carriage all the way. If

some part contacts the vise, re-position the vise.

Press the workpiece flat against the guide fence and the

turn base. Position the workpiece at the desired cutting

position and secure it firmly by tightening the vise knob.

WARNING:

•

The workpiece must be secured firmly against the

turn base and guide fence with the vise during all

operations.

If the workpiece is not properly secured

against the fence the material may move during the

cutting operation causing possible damage to the

blade, causing the material to be thrown and loss of

control resulting in serious personal injury.

Holders

014284

The holders can be installed on either side as a

convenient means of holding workpieces horizontally.

Slip fully the holder rods into the holes in the base. Then

tighten the holders securely with the screws.

WARNING:

• Always support a long workpiece so it is level

with the top surface of the turn base for an

1. Holder

2. Screw

1. Vise arm

2. Vise knob

3. Vise rod

4. Screw

5. Guide fence

1. Sliding fence

2. Clamping screw

1. Support

2. Turn base

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Comments to this Manuals

No comments

Makita LS0815FL Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS0815FL