Makita LS0815FL Instruction Manual download pdf (Page 10)

014274

To turn on the light, press the upper position (ON) of the

switch. To turn off the light, press the lower position

(OFF) of the switch.

CAUTION:

• Do not look in the light or see the source of light

directly.

NOTE:

• Use a dry cloth to wipe the dirt off the lens of lamp.

• Be careful not to scratch the lens of lamp, or it

may to lower the luminance.

ASSEMBLY

WARNING:

• Always be sure that the tool is switched off

and unplugged before working on the tool.

Failure to switch off and unplug the tool may result

in serious personal injury.

Storage of socket wrench with hex wrench on

its other end

014282

The socket wrench is stored as shown in the figure.

When the socket wrench is needed it can be pulled out

of the wrench holder. After using the socket wrench it

can be stored by returning it to the wrench holder.

Installing or removing saw blade

WARNING:

• Always be sure that the tool is switched off

and unplugged before installing or removing

the blade. Accidental start up of the tool may

result in serious personal injury.

• Use only the Makita socket wrench provided to

install or remove the blade. Failure to use the

wrench may result in overtightening or insufficient

tightening of the hex bolt and serious personal

injury.

014303

Lock the handle in the raised position by pushing in the

stopper pin.

010390

To remove the blade, use the socket wrench to loosen the

hex bolt holding the center cover by turning it

counterclockwise. Raise the blade guard and center cover.

010391

Press the shaft lock to lock the spindle and use the

socket wrench to loosen the hex bolt clockwise. Then

remove the hex bolt, outer flange and blade.

NOTE:

• If the inner flange is removed be sure to install it

on the spindle with its protrusion facing away from

the blade. If the flange is installed incorrectly the

flange will rub against the machine.

WARNING:

• Before mounting the blade onto the spindle,

always be sure that the correct ring for the

blade's arbor hole you intend to use is

installed between the inner and the outer

1. Blade case

2. Socket wrench

3. Hex bolt

4. Arrow

5. Shaft lock

1. Socket wrench

2. Blade case

3. Center cover

4. Hex bolt

5. Blade guard

1. Stopper pin

1. Socket wrench

with hex wrench

on its other end

2. Wrench holder

1. Switch for light

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comments to this Manuals

No comments

Makita LS0815FL Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS0815FL