Makita EK7651HD Use and Care Manual download pdf (Page 16)

Operating

Starting

WARNING:

Do not start the engine in locations where refueling has

taken place. Move at least three meters away from the place

where the Power Cutter was fuelled.

Failure to do so may cause ames or re.•

CAUTION:

Before starting engine, be sure to check that the cutting

disc is not touching the ground or any other obstacle.

If the cutting disc is touching the ground or other obstacle, it •

may cause an accident.

As soon as the engine starts, the cutting disc will rotate, so

be fully aware of nearby people and obstacles.

1. Cold-starting

(1) Repeatedly press primer pump until fuel enters it.

(2) Flip switch in direction of

(choke).

(3) Hold down rear handle with a foot and rmly hold down

tubular handle with a hand.

(4) Vigorously pull the start handle repeatedly until the rst ring

up sound is heard.

Warming up

Once engine starts, hold down safety lever, and squeeze and •

release throttle repeatedly for one or two minutes to warm up

the engine.

Once engine speed stabilizes and it revs smoothly from low to •

high speed, warming up is complete.

2. Starting up when engine is warm

Press the primer pump several times. From the outset, place the

switch in the [I] (operating) position, and start the engine using

task (3) of procedure 1 above.

NOTE:

Repeatedly pulling and releasing the starter grip with the •

switch set to choke will ood the engine with fuel, making start

up difcult.

When the engine stops, never squeeze the throttle lever.•

Unnecessarily squeezing the throttle lever with the engine

stopping will ood the engine with fuel, making start up

difcult.

If the engine does become ooded with fuel, remove the •

spark plug, and slowly pull the starter handle several times to

remove the excess fuel. Also, dry the electrode section of the

spark plug.

Do not pull starter handle to the limit of the rope, as doing so •

shortens the lifespan of the rope. Furthermore, gently return

the starter handle without suddenly letting go of it.

Avoid letting the Power Cutter run at maximum idling speed, •

as doing so will shorten the lifespan of the engine.

3. Stopping

To stop the engine, release the throttle, and set the switch to the

(Stop) position.

If the choke lever is wrongly moved to the position to stop the

tool, use half throttle to restart.

Throttle lever

Starter grip

Switch

Safety locking

button

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Makita EK7651HD Use and Care Manual Page 16

Comments to this Manuals

Related products and manuals for Power universal cutters Makita EK7651HD