Makita EK7651HD Use and Care Manual download pdf (Page 13)

PUTTING INTO OPERATION

CAUTION:

Always turn off the engine and pull off the spark plug cap

before doing any work on the Power Cutter! Always wear

protective gloves!

CAUTION:

Start the Power Cutter only after complete assembly and

inspection.

Mounting the cutting disc

WARNING:

When installing a diamond cutting disc, be sure to mount •

it so that the arrow is in the same direction as the outer

ange (6) rotates. Mounting the diamond cutting disc (4) with

its arrow direction opposite to that on the wheel cover may

cause chipping of the disc edge and personal injury.

When installing a cutting disc (4), always use the ring that •

matches the bore of the cutting disc and the diameter of

the spindle (5). Failure to use rings that mate may cause tool

vibration resulting in serious personal injury.

Only use cutting discs with the bore that matches the •

diameter of the ring(s) provided. Using discs that do not mate

may cause tool vibration resulting in serious personal injury.

Inspect a cutting disc for damage. (see the section titled •

“Cutoff discs” in SAFETY PRECAUTIONS.)

1. Insert the star-shaped wrench (2) into the hole (8) to prevent

the spindle (5) from rotating.

NOTE: When the holder of the pressure water system is installed

in the hole in the tool, remove it before mounting the

cutting disc.

2. While holding on the wrench (2) in that position, use the

combination wrench (1) provided and turn the bolt (7) securing

the disc counterclockwise and remove the bolt (7) and outer

ange (6).

3. Mount a diamond cutting disc/cut-off abrasive disc (4) on the

arbor (5). And then put the outer ange (6) on the spindle

so that the two parallel at surface on the outer ange t the

spindle at surface and rmly tighten the bolt clockwise.

To install a cutting disc, mount a ring with the same matching

diameter as the disc bore and the O ring provided to retain the

ring on the spindle before installing a diamond cutting disc.

And then install the cutting disc.

NOTE: Tighten the hex bolt rmly (25 - 31 Nm), as otherwise the

cutting wheel may slip during cutting.

Schematic

drawing

For the following work, use the assembly tools included with

delivery:

1. 13/16 AF combination wrench

2. Star-sharped wrench

3. Carburetor adjustment screwdriver

4. Adapter ring

Place the Power Cutter on a stable surface and carry out the

following assembly steps:

No air lter is installed!

Before operation, squeeze the supplied lter several times so

that oil is evenly immersed in the entire lter. Insert an oiled

foam lter (pre-lter), as shown in the adjacent illustration! To

do this, take off the lter cover (see the chapter on Cleaning/

changing the air lter).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Makita EK7651HD Use and Care Manual Page 13

Comments to this Manuals

Related products and manuals for Power universal cutters Makita EK7651HD