Makita LM430D Instruction Manual

1 ENGLISH (Original instructions) INSTRUCTION MANUAL IMPORTANT: Read Before Using. Cordless Lawn Mower BLM430 LM430D 012295

10 213 012304 1. Put the mower on its side so that the mowing height adjusting lever is placed on the upper side. 2. To lock the blade, insert a sc

11 OPERATION Mowing WARNING: • Before mowing, clear away sticks and stones from mowing area. Furthermore, clear away any weeds from mowing area in a

12 4. Check all nuts, bolts, knobs, screws, fasteners etc. for tightness. 5. Inspect moving parts for damage, breakage, and wear. Have repairs made

13 1 012600 NOTE: • When putting the mower in the upright position, do not hold the handle but use the front grip of the mower. 012420 4. Store t

14 Malfunction statusMower does not start.CauseBattery cartridge is not installed.Battery problem (under voltage)Cutting height set is too low.Battery

15

16 Makita CorporationAnjo, Aichi, Japanwww.makita.com 885081A229

2 ENGLISH (Original instructions) SPECIFICATIONS Model BLM430 / LM430D Mowing width 430 mm No load speed 3,600 min-1 during operation 1,450 mm -1,4

3 ENH217-1 For European countries only EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following M

4 19. Remove key before servicing, cleaning or removing material from the gardening appliance. 20. Use only the manufacturer genuine blades specifie

5 SAVE THESE INSTRUCTIONS. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rule

6 1 012297 3. Insert the lock key in the place shown in the figure as far as it will go. 4. Close the battery cover and push it on until it is latc

7 1 012384 To remove the BCV02, press on the hook of the BCV02 and withdraw it with both hands. Power switch action WARNING: • Before inserting the

8 NOTE: • The mowing height figures should be used just as a guideline, as the state of the lawn or ground may cause lawn height to be slightly diffe

9 123 012385 Expand the lower handle to its both sides and with it expanded in that position pivot it backward and then fit it in the groove in the d