Makita JN3201 Instruction Manual download pdf (Page 5)

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Punch replacement

013357

Fit the wrench provided onto the lock nut and tap the

handle lightly with a hammer to loosen the lock nut.

Take off the die hol de r and use a wrench to re move the

screw. Then remove the punch.

013358

To insta ll the pu nc h, i nsert it i nto the punch holder wi th

its cutting edge facing forward so that the pin in the

punch holder fits into the groove in the punch. Install the

screw and lock nut. Then tighten them securely.

NOTE:

• When installing the screw and lock nut, be sure to

tighten securely. If they become loose during

operation, the tool may break down.

004785

OPERATION

CAUTION:

• Hold the tool firmly with one hand on the main

handle when performing the tool.

Pre-lubrication

Coat the cutting line with machine oil to increase the

punch and die service life. This is particularly important

when cutting aluminum.

Cutting method

013359

Smooth cutting is achieved by holding the tool upright

and applying gentle pressure in the cutting direction.

Apply tool oil to the punch about every 10 meters (32.8

feet) of mild steel or stainless steel to be cut. Light oil or

kerosene should be used to keep an aluminum

lubricated continuously. Failure to lubricate aluminum in

the cut will cause chips to adhere to the tool, dulling the

die and punch and increasing load on the motor.

Cutouts

013360

Cutouts can be done by first opening a round hole of

about 42 mm (1-5/8") diameter or more in the material.

Cutting stainless steel

004792

1. Screw

2. Hex wrench

3. Washer

4. Insert washer in

between

5. Die

1. Cutting edge

2. Punch

3. Groove

4. Punch holder

5. Pin

1. Punch

2. Screw

3. Wrench

1. Wrench

2. Lock nut

3. Die holder

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

Makita JN3201 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Makita JN3201