Makita 6405 Instruction Manual download pdf (Page 6)

CAUTION

Before plugging in the tool, always check to

see

that the switch trigger actuates properly

Always check the direction of rotation before drilling.

Use the reversing switch lever only when the tool comes to

complete stop. Changing

When not operating the tool, keep the reversing switch lever in the neutral position.

*Pulling the trigger hard when the reversing switch lever

in the neutral position can

and returns to the

"OFF"

position when released.

the direction of rotation before the tool stops may ruin the tool.

cause switch breakage.

Drilling operation

Drilling in wood

When drilling holes in the wood, use

wood drill with

guide screw. The guide screw

makes

bore naturally by itself,

you do not need to apply any pressure to the tool.

Drilling in metal

To prevent the bit from slipping when starting

hole, make an indentation with

center-

punch and hammer

the point to be drilled.

Place

the point of the bit in the indenta-

tion and start drilling.

Use

cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

CAUTION

*Pressing excessively on the tool will not speed up the drilling. In fact, this excessive

pressure will only

serve

to damage the tip of your bit, decrease the tool performance

and shorten the service life of the tool.

.There

tremendous force exerted on the tool/bit

the time of hole break through.

Hold the tool firmly and exert care when the bit begins to break through the workpiece.

.Always grip the small workpiece firmly with

vise

holding means.

*A stuck bit can be removed simply by setting the reversing switch to reverse rotation

in order to back out. However, the tool will pull away easily unless you hold

firmly

before starting the tool.

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Makita 6405 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Makita 6405