Makita 2708 Instruction Manual download pdf (Page 6)

Adjusting the bevel angle

009027

Loosen the lock lever counterclockwise and turn the

handwheel until the desired angle (0° - 45°) is obtained.

The bevel angle is indicated by the arrow pointer.

After obtaining the desired angle, tighten the lock lever

clockwise to secure the adjustment.

CAUTION:

• After adjusting the bevel angle, be sure to tighten

the lock lever securely.

Adjusting positive stops

008762

(A)

(B)

006157

The tool is equipped with positive stops at 90° and 45° to

the table surface. To check and adjust the positive stops,

proceed as follows:

Move the handwheel as far as possible by turning it. Place a

triangular rule on the table and check to see if the blade is at

90° or 45° to the table surface. If the blade is at an angle

shown in Fig. A, turn the adjusting screws clockwise; if it is

at an angle shown in Fig. B, turn the adjusting screws

counterclockwise to adjust the positive stops.

After adjusting the positive stops, set the blade at 90° to

the table surface. Then adjust the arrow pointer so that

its right edge is aligned to the 0° graduation.

008763

Switch action

CAUTION:

• Remove workpiece from the table.

• Switch off the tool and then press in the restart

button.

OFF

009028

CAUTION:

• Before plugging in the tool, always be sure that the

tool is switched off.

To start the tool, raise the switch lever. To stop it, lower

the switch lever.

009046

Sub table (R)

008765

1. Screws

1. Switch

2. Restart button

1. Switch

2. Restart button

1. Arrow pointer

1. 90 ﾟ adjusting

screw

2. 45 ﾟ adjusting

screw

1. Arrow pointer

2. Lock lever

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Makita 2708 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Makita 2708