Makita 2708 Instruction Manual

1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION Table SawMLT100 009695 IMPORTANT: Read Before Using.

10 12 009699 Connecting to vacuum cleaner Cleaner operations can be performed by connecting the tool to Makita vacuum cleaner or dust collector. 0

11 • When cutting long or large workpieces, always provide adequate support behind the table. DO NOT allow a long board to move or shift on the table

12 Use the miter gauge for the 4 types of cutting shown in the figure. CAUTION: • Secure the knob on the miter gauge carefully. • Avoid creep of wo

13 Replacing carbon brushes 007834 Remove and check the carbon brushes regularly. Replace when they wear down to 3 mm in length. Keep the carbon br

14

15

16 Makita CorporationAnjo, Aichi, Japanwww.makita.com JM2708B082

2 ENGLISH (Original instructions) SPECIFICATIONS Model MLT100 Arbor hole 25.4 mm Blade diameter 255 mm Blade body thickness 1.9 mm or less 90° 90.5

3 8. Dress properly. Do not wear loose clothing or jewellery, they can be caught in moving parts. Rubber gloves and non-skid footwear are recommended

4 12. Use saw-blade guard and riving knife for every operation for which it can be used, including all through sawing operations. Always install the

5 INSTALLATION Positioning table saw 588 mm1340 mm 009109 117 mm2 009108 12 006243 Locate the table saw in a well lit and level area where you c

6 Adjusting the bevel angle 12 009027 Loosen the lock lever counterclockwise and turn the handwheel until the desired angle (0° - 45°) is obtained.

7 1 008766 This tool is provided with the sub table (R) on the right side of the main table. To use the sub table (R), loosen two screws on the r

8 12345 008770 CAUTION: • The ring 25.4 mm in outer diameter is factory-installed onto the spindle. • Keep the flange surface clean of dirt or o

9 124 mm-5 mm 009710 Assembling slide table 1223 009708 Secure slide rails with bolts provided with the tool. Remove the clamping screw from the s