Makita 4351CTJ Datasheet download pdf (Page 5)

faster but the service life of the blade will be reduced.

Number on adjusting dial

4 - 5

Mild steel 3 - 5

Stainless steel 3 - 4

Aluminum 3 - 5

Plastics 1 - 4

Workpiece to be cut

Wood

006368

CAUTION:

• The speed adjusting dial can be turned only as far

as 5 and back to 1. Do not force it past 5 or 1, or

the speed adjusting function may no longer work.

The tools equipped with electronic function are easy to

operate because of the following features.

Constant speed control

Electronic speed control for obtaining constant speed.

Possible to get fine finish, because the rotating speed is

kept constant even under load condition.

Soft start feature

Safety and soft start because of suppressed starting

shock.

Lighting up the lamps

For 4351FCT only

CAUTION:

• Do not look in the light or see the source of light

directly.

To turn on the lamp, pull the trigger. Release the trigger

to turn it off.

NOTE:

• Use a dry cloth to wipe the dirt off the lens of lamp.

Be careful not to scratch the lens of lamp, or it may

lower the illumination.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Installing or removing saw blade

CAUTION:

• Always clean out all chips or foreign matter

adhering to the blade and/or blade holder. Failure

to do so may cause insufficient tightening of the

blade, resulting in a serious personal injury.

• Do not touch the blade or the workpiece

immediately after operation; they may be

extremely hot and could burn your skin.

• Tighten the saw blade securely. Failure to do so

may cause a serious injury.

• When you remove the saw blade, be careful not to

hurt your fingers with the top of the blade or the tips

of workpiece.

To install the blade, open the tool opener to the position

shown in the figure.

008007

Keeping that situation, insert the saw blade into the

blade clamp as far as the two protrusions of the blade

can not be seen.

008008

Return the tool opener to its original position.

After installing, always make sure that the blade is

securely held in place by trying to pull it out.

CAUTION:

• Do not open the tool opener excessively, or it may

cause tool damage.

To remove the blade, open the tool opener to the

position shown in the figure. Pull the saw blade out

toward the base.

008009

1. Jig saw blade

1. Blade clamp

2. Jig saw blade

3. Protrusions

1. Tool opener

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments

Makita 4351CTJ Datasheet Page 5

Comments to this Manuals

Related products and manuals for Power jigsaws Makita 4351CTJ