Makita 6503D Specifications download pdf (Page 7)

Reversing switch action

This tool has a reversing switch to change the direction of

rotation. Depress the reversing switch lever from the A side

for clockwise rotation or from the B side for counterclockwise

rotation.

When the reversing switch lever is in the neutral position, the

switch trigger cannot be pulled.

CAUTION:

• Always check the direction of rotation before operation.

• Use the reversing switch only after the tool comes to a

complete stop. Changing the direction of rotation before

the tool stops may damage the tool.

• When not operating the tool, always set the reversing

switch lever to the neutral position.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out any

work on the tool.

Installing or removing driver bit or drill bit

Hold the ring and turn the sleeve counterclockwise to open

the chuck jaws. Place the bit in the chuck as far as it will go.

Hold the ring firmly and turn the sleeve clockwise to tighten

the chuck.

To remove the bit, hold the ring and turn the sleeve counter-

clockwise.

1. Reversing switch lever

002089

1. Sleeve

2. Ring

3. Tighten

002120

1 2 3 4 5 6 7 8 ... 16

No comments

Makita 6503D Specifications Page 7