Makita AN8300 Instruction Manual

Pneumatic Framing Nailer Dimensions Min hose Air pressure Nail length Nail capacity IL x H x Wl diameter MODEL AN8300 Net weight INSTRUCTION MANUA

TOOL INSTALLATION INSTRUCTIONS AND USE Lubrication To insure maximum performance, install the air set (oiler, regulator, air filter) as clo

While pulling the pusher, press the lock lever to unlock the pusher. Then return the pusher while pressing the lock lever. I Selecting compressor

Operation 1)To drive a nail, you may place the contact arm 2) Pull the trigger first and then place the contact arm No, 1 method is for int

Nails Handle nail strips and their box carefully. If the nail strips have been handled roughly, they may be out of shape or their connector br

MAINTENANCE CAUTION: Always be sure that the air hose is disconnected from the tool before attempting to perform inspection or maintenance Mai

Maintenance of compressor, air set and air hose After operation, always drain the compressor tank and the air filter. If the tool is used without

(MEMO) MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warr

IMPORTANT SAFETY TOOL USE INSTRUCTIONS WARNING: WHEN USING THIS TOOL, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RIS

General Tool Handling Guidelines: I 1. Always assume that the tool contains fasteners. 2. Do not point the tool toward yourself or anyone whether it

There may be local regulations concerning noise I which must be complied with by keeping noise levels within prescribed limits. In certain cases,

Always check the tool for its overall condition and loose screws before operation. Tighten as required. Make sure all safety systems are in working or

Use only nails specified in this manual. The use of any other nails may cause malfunction of the tool. Do not permit those uninstructed to use the too

On rooftops and other high locations, nail as you move forward. It is easy to lose your footing if you nail while inching backward. When nailing agai

.Do not point the ejection port at anyone in the vicinity. Keep hands and feet away from the ejection port area. *When the air hose is connected, d

Always disconnect the air hose and remove all of the nails before inspection, maintenance, relocating, or after operation is over. Perform cleaning a