Makita RT0700C Instruction Manual download pdf (Page 7)

• When using the trimmer shoe, the straight guide or

the trimmer guide, be sure to keep it on the right

side in the feed direction. This will help to keep it

flush with the side of the workpiece.

001985

CAUTION:

• Since excessive cutting may cause overload of the

motor or difficulty in controlling the tool, the depth

of cut should not be more than 3 mm at a pass

when cutting grooves. When you wish to cut

grooves more than 3 mm deep, make several

passes with progressively deeper bit settings.

Templet guide (optional accessory)

011838

The templet guide provides a sleeve through which the bit

passes, allowing use of the trimmer with templet patterns.

Loosen the screws and remove the base protector.

Place the templet guide on the base and replace the

base protector. Then secure the base protector by

tightening the screws.

011839

Secure the templet to the workpiece. Place the tool on

the templet and move the tool with the templet guide

sliding along the side of the templet.

10mm (3/8")

011982

NOTE:

• The workpiece will be cut a slightly different size

from the templet. Allow for the distance (X)

between the router bit and the outside of the

templet guide. The distance (X) can be calculated

by using the following equation:

Distance (X) = (outside diameter of the templet guide -

router bit diameter) / 2

Straight guide (optional accessory)

011840

The straight guide is effectively used for straight cuts

when chamfering or grooving.

001990

Attach the guide plate to the straight guide with the bolt

and the wing nut.

011841

Attach the straight guide with the clamp screw (A).

Loosen the wing nut on the straight guide and adjust the

1. Clamp screw (A)

2. Straight guide

3. Wing nut

4. Base

1. Bolt

2. Guide plate

3. Straight guide

4. Wing nut

1. Straight bit

2. Base

3. Templet

4. Distance (X)

5. Workpiece

6. Templet guide

7. Base protector

1. Base protector

2. Screws

3. Screwdriver

1. Feed direction

2. Bit revolving

direction

3. Workpiece

4. Straight guide

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments

Makita RT0700C Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Grass trimmers Makita RT0700C