Makita RT0700C Instruction Manual download pdf (Page 13)

the wing bolts to secure the straight guide in place.

When cutting, move the tool with the straight guide flush

with the side of the workpiece.

011850

If the distance (A) between the side of the workpiece and

the cutting position is too wide for the straight guide, or if

the side of the workpiece is not straight, the straight guide

cannot be used. In this case, firmly clamp a straight board

to the workpiece and use it as a guide against the router

base. Feed the tool in the direction of the arrow.

Templet guide (optional accessory)

011851

The templet guide provides a sleeve through which the

bit passes, allowing use of the tool with templet patterns.

To install the templet guide, loosen the screws on the

tool base, insert the templet guide and then tighten the

screws.

011852

Secure the templet to the workpiece. Place the tool on

the templet and move the tool with the templet guide

sliding along the side of the templet.

003695

NOTE:

• The workpiece will be cut a slightly different size

from the templet. Allow for the distance (X)

between the bit and the outside of the templet

guide. The distance (X) can be calculated by using

the following equation:

Distance (X) = (outside diameter of the templet

guide - bit diameter) / 2

Dust nozzle sets

For the trimmer base

011989

1. Dust nozzle

2. Thumb screw

3. Trimmer base

1. Bit

2. Base

3. Templet

4. Workpiece

5. Distance (X)

6. Outside

diameter of the

templet guide

7. Templet guide

1. Screw

2. Base

3. Templet

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Makita RT0700C Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Grass trimmers Makita RT0700C