Makita RT0700C Instruction Manual download pdf (Page 5)

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and

unplugged before adjusting or checking function on

the tool.

Adjusting bit protrusion

011834

To adjust the bit protrusion, loosen the locking lever and

move the tool base up or down as desired by turning the

adjusting screw. After adjusting, tighten the locking lever

firmly to secure the tool base.

NOTE:

• When the tool is not secured even if the locking

lever is tightened, tighten the hex nut and then

tighten the locking lever.

Switch action

011836

CAUTION:

• Before plugging in the tool, always check to see

that the tool is switched off.

To start the tool, press the "ON ( I )" side of the switch.

To stop the tool, press the "OFF (O)" side of the switch.

Electronic function

The tool equipped with electronic function are easy to

operate because of the following features.

Constant speed control

Electronic speed control for obtaining constant speed.

Possible to get fine finish, because the rotating speed is

kept constant even under load condition.

Soft start

Soft-start feature minimizes start-up shock, and makes

the tool start smoothly.

Speed adjusting dial

011835

The tool speed can be changed by turning the speed

adjusting dial to a given number setting from 1 to 6.

Higher speed is obtained when the dial is turned in the

direction of number 6. And lower speed is obtained when it

is turned in the direction of number 1.

This allows the ideal speed to be selected for optimum

material processing, i.e. the speed can be correctly

adjusted to suit the material and bit diameter.

Refer to the table for the relationship between the number

settings on the dial and the approximate tool speed.

Number min

-1

10,000

30,000

12,000

17,000

22,000

27,000

011932

CAUTION:

• If the tool is operated continuously at low speeds

for a long time, the motor will get overloaded,

resulting in tool malfunction.

• The speed adjusting dial can be turned only as far

as 6 and back to 1. Do not force it past 6 or 1, or

the speed adjusting function may no longer work.

1. Speed adjusting

dial

1. Switch

2. OFF (O) side

3. ON ( I ) side

1. Bit protrusion

2. Tool base

3. Scale

4. Locking lever

5. Adjusting screw

6. Hex nut

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Makita RT0700C Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Grass trimmers Makita RT0700C