Makita EM4251 Service Manual download pdf (Page 44)

p 41 / 45

9 - 2 Reassembling

(1) First, pass starter rope through starter knob and

make an overhead knob as shown in Fig. 9 - 3.

Next, pass the opposite side of starter rope from

starter case to reel, make a knot in the same way

as in starter knob side and then, put the rope end

securely into rope housing in reel.

Then, apply a small amount of grease on starter

shaft and on spiral spring.

(2) Check that spring is securely set in reel and form

the spring end to measure 1 to 2mm for clearance

between inner end of the spring and the reel bushing

edge so that the hook catches securely as shown in

Fig. 9 - 4.

The shape of spring inner end (approx.. 10 cm from

the end) may be adjusted with pliers, if necessary.

(3) Prior to inserting reel in starter case, wind starter

rope in the direction of arrow of Fig. 5, take out

the third turn of starter rope from reel notch and

then, install reel securely inside the starter case

for spiral spring inner end hook to get firmly

caught.

Next, hold starter rope as shown in Fig. 5 and

rotate reel 4 to 5 turns in the direction of arrow by

utilizing reel notch.

After winding reel, hold it securely to prevent it

from reverse turn and pull out starter knob to

stretch the rope tight and then, release knob slowly.

Finally, reassemble the parts in reverse order of

disassembling shown in Fig. 9 - 3.

Tighten set screw securely.

* This concludes disassembling / reassembling.

Check the following to make sure that the parts

are securely installed.

Approx.

10mm

Approx.

10mm

Fig. 9 - 3

Fig. 9 - 4

Fig. 9 - 5

Spiral spring end

Reel

Reel bush

1 to 2mm

Starter shaft

Hook

Reel

Apply grease

Spiral spring end

1 2 ... 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Makita EM4251 Service Manual Page 44

Comments to this Manuals

Related products and manuals for Engine Makita EM4251