Makita EM4251 Service Manual download pdf (Page 36)

P 33 / 45

The tightening torque

for bolt M4-16 : 1 - 2 N.m

(10 - 20 Kg.cm)

(0.7 - 1.4 ft.lb.)

The tightening torque

for screw M5-12 : 2 - 4 N.m

(20 - 40 Kg.cm)

(1.4 - 2.9 ft.lb.)

5 - 3 - 19 Engine cover, Stop switch and Plug cover

Installing engine cover, stop switch and plug cover.

(1) In advance sub-assemble stop switch

and engine cover. Connect stop switch side

terminal.

(2) Fasten 2 terminals of stop switch.

Either fasten terminal can be connected with

coil terminal.

Fasten 2 terminals of coil. The cylinder side

is the grounding terminal.

(3) Install engine cover by placing it on

engine from above, and screw its

front side on housing blower at 2 places

and its rear side on crankcase at 2 places

(screw the rear side together with recoil.)

(4) Install plug cover by hooking the claw located

at its lower part on engine cover first and then

fitting its upper part.

Fasten 2 pcs. of screw M5 x 12mm

and 2 pcs. of screw M6 x 16mm.

(Note)

When installing engine cover, make sure

that there is no coil terminal disconnected

and no voltage cord bent.

Fig. 5 - 48

Cylinder cover

Muffler

Carburetor insulator shall be

placed inside.

Fig. 5 - 49

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

No comments

Makita EM4251 Service Manual Page 36