Makita XT252T Use and Care Manual download pdf (Page 7)

Empty signal for remaining

battery capacity

014071

Pulling the trigger switch when the remaining battery

capacity becomes very low makes LED indicator flicker.

If the tool is used continuously with the LED indicator

flickering up and the battery power is almost used up,

the LED indicator will light up and the tool itself will stop.

Please refer to the following table for the LED indicator

status and the remaining battery capacity.

LED indicator status

OFF

Lighting on

Flickering

Remaining battery capacity

Enough

20%

Very low and the tool will stops

011188

NOTE:

• When all lamps on the switch panel go out, the

tool is turned off to save the battery power. The

remaining battery capacity can be checked by

pulling the switch trigger to the extent that the tool

does not operate.

• All of the lamps on the switch panel go out

approximately one minute after releasing the

switch trigger.

• When the tool temperature is high, the LED

indicator may flicker or light up.

• If the LED indicator lights up and the tool stops

even with a recharged battery cartridge, cool down

the tool temperature fully. When the status is still

unchanged, stop using and have the tool repaired

by a Makita local service center.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out

any work on the tool.

Installing or removing driver bit or socket bit

12 mm

(15/32”)

9 mm

(3/8”)

001266

Use only the driver bit or socket bit shown in the figure.

Do not use any other driver bit or socket bit.

009205

To install the bit, insert the bit into the sleeve as far as it

will go.

To remove the bit, pull the sleeve in the direction of the

arrow and pull the bit out.

NOTE:

• If the bit is not inserted deep enough into the

sleeve, the sleeve will not return to its original

position and the bit will not be secured. In this

case, try re-inserting the bit according to the

instructions above.

• When it is difficult to insert the bit, pull the sleeve

and insert it into the sleeve as far as it will go.

• After inserting the bit, make sure that it is firmly

secured. If it comes out, do not use it.

Hook

014068

The hook is convenient for temporarily hanging the tool.

This can be installed on either side of the tool.

To install the hook, insert it into a groove in the tool

housing on either side and then secure it with a screw.

To remove, loosen the screw and then take it out.

1. Groove

2. Hook

3. Screw

1. Bit

2. Sleeve

1. LED indicator

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Comments to this Manuals

No comments

Makita XT252T Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Cordless combi drills Makita XT252T