Makita XT252T Use and Care Manual download pdf (Page 6)

• During the operation of switch trigger, the light

status cannot be changed.

• For approximately 10 seconds after releasing the

switch trigger, the light status can be switched.

Reversing switch action

009211

This tool has a reversing switch to change the direction

of rotation. Depress the reversing switch lever from the

A side for clockwise rotation or from the B side for

counterclockwise rotation.

When the reversing switch lever is in the neutral

position, the switch trigger cannot be pulled.

CAUTION:

• Always check the direction of rotation before

operation.

• Use the reversing switch only after the tool comes

to a complete stop. Changing the direction of

rotation before the tool stops may damage the tool.

• When not operating the tool, always set the

reversing switch lever to the neutral position.

Changing the hammering force

011217

Hammering force grade

displayed on panel

Maximum

blows

Application Work

Hard

Medium

Soft

Tightening when force

and speed are desired.

Tightening when a good

finishing is needed.

Tightening when excessive

tightening need to be avoided

because of potentially clogged

female screw and broken or

damaged screw head.

Tightening in underwork

material/ Tightening long

screws/ Tightening bolts.

Tightening in the finishing

board, plaster board.

Tightening sash screw/

Tightening small screws

such as M6.

3,400 /min

2,800 /min

1,300 /min

014072

The hammering force can be changed in three steps:

hard, medium and soft.

This allows a tightening suitable to the work.

Every time the hammering force button

is pressed, the

number of blows changes in three steps.

For approximately one minute after releasing the switch

trigger, the hammering force can be changed.

NOTE:

•

When all lamps on the switch panel go out, the tool

is turned off to save the battery power. The hammer

force grade can be checked by pulling the switch

trigger to the extent that the tool does not operate.

• During the operation of switch trigger, the hammer

force grade cannot be changed.

1. Changed in

three steps

2. Hard

3. Medium

4. Soft

5. Hammering

force button

1. Reversing

switch lever

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Comments to this Manuals

No comments

Makita XT252T Use and Care Manual Page 6

Comments to this Manuals

Related products and manuals for Cordless combi drills Makita XT252T