Makita 9060DBL Specifications download pdf (Page 11)

• ALWAYS use guard with wire wheel brushes, assuring

diameter of wheel fits inside guard. Wheel can shatter

during use and guard helps to reduce chances of

personal injury.

Unplug tool and place it upside down allowing easy access

to spindle. Remove any accessories on spindle. Thread wire

wheel brush onto spindle and tighten with the wrenches.

When using wire wheel brush, avoid applying too much pres-

sure which causes over bending of wires, leading to prema-

ture breakage.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

The tool and its air vents have to be kept clean. Regularly

clean the tool’s air vents or whenever the vents start to

become obstructed.

Replacing carbon brushes

When the resin insulating tip inside the carbon brush is

exposed to contact the commutator, it will automatically shut

off the motor. When this occurs, both carbon brushes should

be replaced. Keep the carbon brushes clean and free to slip

in the holders.

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.

1. Exhaust vent

2. Inhalation vent

001170

1. Commutator

2. Insulating tip

3. Carbon brush

1. Brush holder cap

2. Screwdriver

001146

001154

1 ... 10 11 12 13 14 15 16

No comments

Makita 9060DBL Specifications Page 11