Makita 9060DBL Specifications download pdf (Page 10)

ALWAYS hold the tool firmly with one hand on rear handle

and the other on the side handle. Turn the tool on and then

apply the wheel or disc to the workpiece.

In general, keep the edge of the wheel or disc at an angle of

about 15 degrees to the workpiece surface.

During the break-in period with a new wheel, do not work the

grinder in the B direction or it will cut into the workpiece.

Once the edge of the wheel has been rounded off by use, the

wheel may be worked in both A and B direction.

Operation with wire cup brush

(optional accessory)

CAUTION:

• Check operation of brush by running tool with no load,

insuring that no one is in front of or in line with brush.

• Do not use brush that is damaged, or which is out of

balance. Use of damaged brush could increase potential

for injury from contact with broken brush wires.

Unplug tool and place it upside down allowing easy access

to spindle. Remove any accessories on spindle. Mount ure-

thane washer then thread wire cup brush onto spindle and

tighten with supplied wrench. When using brush, avoid

applying too much pressure which causes over bending of

wires, leading to premature breakage.

NOTE:

• When using wire cup brush, mount urethane washer to

the spindle. It will make it easier to remove wire cup

brush.

Operation with wire wheel brush

(optional accessory)

CAUTION:

• Check operation of wire wheel brush by running tool with

no load, insuring that no one is in front of or in line with

the wire wheel brush.

• Do not use wire wheel brush that is damaged, or which

is out of balance. Use of damaged wire wheel brush

could increase potential for injury from contact with

broken wires.

1. Wire cup brush

2. Urethane washer

001141

1. Wire wheel brush

001234

1 ... 9 10 11 12 13 14 15 16

No comments

Makita 9060DBL Specifications Page 10