Makita VC4710 Operations Instructions download pdf (Page 23)

Fault Cause Remedy

• Motor does not start • Check the branch circuit pro-

tection.

• Overload protection switch has

tripped.

• Connect mains fuse.

• Switch off the vacuum cleaner

and allow it to cool for approx.

5 minutes. If the cleaner can-

not be started again, contact

the Makita service department.

• Motor does not run in automa-

tic mode

• Power tool is defective or not

connected properly.

• The power rating of the electri-

cal tool is too low.

• Check that the power tool

works or that the plug is insert-

ed correctly.

• Note that minimum current

rating must be 0,35 Amps.

• Reduced suction power • Suction power selected with

suction power control is too

low.

• Clogged suction hose/nozzle.

• Tank, disposal bag or filter bag

is full.

• Filter element is clogged.

• Seal between tank and upper

section of vacuum cleaner is

faulty or missing.

• Set suction power in accord-

ance with section “Control/op-

eration“.

• Clean suction hose/nozzle

• See “Wet suction” or “Replace-

ment of filter bag + disposal

bag” sections.

• See section “Wet suction”,

“Control/operation”.

• Replacement of filter element.

• Replace seal.

• No suction power during wet

cleaning

• Tank is full. • Switch off the cleaner. Empty

the tank.

Makita VC4710

Original Instruction

7 Troubleshooting

Do not attempt to repair vacuum by yourself. To maintaine product safety and reliability, repairs and

other maintenance or adjustments should be performed by Makita or authorized service centers, always

using Makita replacement parts.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Comments to this Manuals

No comments

Makita VC4710 Operations Instructions Page 23

Comments to this Manuals

Related products and manuals for Vacuum cleaners Makita VC4710