Makita HR3210FCT Instruction Manual download pdf (Page 5)

NOTE:

• Use a dry cloth to wipe the dirt off the lens of lamp.

Be careful not to scratch the lens of lamp, or it may

lower the illumination.

Speed change

008538

The revolutions and blows per minute can be adjusted

just by turning the adjusting dial. The dial is marked 1

(lowest speed) to 5 (full speed).

Refer to the table below for the relationship between the

number settings on the adjusting dial and the

revolutions/blows per minute.

Number on

adjusting dial

Revolutions per

minute

Blows per minute

630

590

480

370

315

3,300

3,100

2,500

1,900

1,650

008550

CAUTION:

• If the tool is operated continuously at low speeds

for a long time, the motor will get overloaded,

resulting in tool malfunction.

• The speed adjusting dial can be turned only as far

as 5 and back to 1. Do not force it past 5 or 1, or

the speed adjusting function may no longer work.

Changing the quick change chuck for

SDS-plus

For Model HR3210FCT

The quick change chuck for SDS-plus can be easily

exchanged for the quick change drill chuck.

Removing the quick change chuck for SDS-plus

008608

CAUTION:

• Before removing the quick change chuck for

SDS-plus always remove the bit.

Hold the change cover with the thumb and the middle

finger and pull it in the direction arrow 1. With the

change cover pulled in that direction, hold the chuck

cover with the index finger. While holding the chuck

cover so, pull out the quick change chuck for SDS-plus

in the direction of arrow 2 at a stroke.

Attaching the quick change drill chuck

008552

Grasp the change cover and place the quick change drill

chuck on the spindle of the tool.

Make sure that the quick change drill chuck is secured

by trying to pull it several times.

Selecting the action mode

Rotation with hammering

008540

For drilling in concrete, masonry, etc., depress the lock

button and rotate the change lever so that the pointer

points to the

symbol. Use a tungsten-carbide tipped

bit.

Rotation only

008600

1. Lock button

2. Change lever

3. Pointer

1. Lock button

2. Pointer

3. Change lever

1. Spindle

2. Quick change

drill chuck

3. Change cover

1. Quick change

chuck for

SDS-plus

2. Change cover

3. Chuck cover

1. Adjusting dial

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comments to this Manuals

No comments

Makita HR3210FCT Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HR3210FCT