Makita HP1620 Specifications

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.Hammer DrillMODEL HP

10Blow-out bulb (optional accessory)After drilling the hole, use the blow-out bulb to clean the dustout of the hole.Drilling operationWhen drilling in

11MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspection ormaintenance.To maintain pro

Memo12

13FoldCutStampTimbreMakita Canada Inc.1950 Forbes Street,Whitby, OntarioL1N 7B7

14Your answers to the following questions are appreciated.Date Purchased Model No.Serial No.Initial Last NameStreet AddressCity ProvinceAGE:Male Femal

15Factory Service CentresFor the authorized service centre nearest you please refer to the local yellow pages directory under “tools” or con-tact our

Warranty PolicyEvery Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be free of defects fromworkmanship

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

3trician to install a polarized outlet. Do notchange the plug in any way. Double insula-tion eliminates the need for the three wiregrounded power co

422. Use only accessories that are recom-mended by the manufacturer for yourmodel. Accessories that may be suitable forone tool, may become hazardous

56. Do not touch the bit or the workpieceimmediately after operation; they may beextremely hot and could burn your skin.7. Some material contains chem

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Reversing switch actionThis tool has a reversing switch to change the direction ofrotation. Move the reversing switch to the position (Aside) for c

8Installing or removing drill bitFor Model HP1620, HP1620FTo install the bit, place it in the chuck as far as it will go.Tighten the chuck by hand. Pl

9Depth gaugeThe depth gauge is convenient for drilling holes of uniformdepth. Loosen the side grip and insert the depth gauge intothe hole in the side