Makita AD02ZW Use and Care Manual download pdf (Page 5)

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before adjusting or

checking function on the tool.

Installing or removing battery cartridge

CAUTION:

• Always switch off the tool before installing or

removing of the battery cartridge.

• Hold the tool and the battery cartridge firmly

when installing or removing battery cartridge.

Failure to hold the tool and the battery cartridge

firmly may cause them to slip off your hands and

result in damage to the tool and battery cartridge

and a personal injury.

013259

To remove the battery cartridge, withdraw it from the

tool while pressing the buttons on both sides of the

cartridge.

To install the battery cartridge, hold it so that the battery

cartridge front shape fits to that of the battery

installment opening and slip it into place. Insert it all the

way until it locks in place with a little click.

CAUTION:

• Always insert the battery cartridge all the way until

it locks in place. If not, it may accidentally fall out

of the tool, causing injury to you or someone

around you.

• Do not install the battery cartridge forcibly. If the

cartridge does not slide in easily, it is not being

inserted correctly.

Battery protection system

The tool is equipped with a battery protection system.

This system automatically cuts off power to the motor to

extend battery life.

The tool will automatically stop during operation if the

tool and/or battery are placed under one of the following

conditions:

• Overloaded:

The tool is operated in a manner that causes

it to draw an abnormally high current.

In this situation, release the switch trigger on

the tool and stop the application that caused

the tool to become overloaded. Then pull the

switch trigger again to restart.

• Low battery voltage:

The remaining battery capacity is too low

and the tool will not operate. If you pull the

switch trigger, the motor runs again but stops

soon. In this situation, remove and recharge

the battery.

Switch action

013253

CAUTION:

• Before inserting the battery cartridge into the tool,

always check to see that the switch trigger

actuates properly and returns to the "OFF"

position when released.

To start the tool, simply pull the switch trigger. Tool

speed is increased by increasing pressure on the switch

trigger. Release the switch trigger to stop.

Electric brake

This tool is equipped with an electric brake. If the tool

consistently fails to quickly stop after switch trigger

release, have tool serviced at a Makita service center.

CAUTION:

• Be sure to hold the tool firmly before the tool is

switched off.

Lighting up the front lamp

For model AD01

013254

1. Lamp

1. Switch trigger

1. Button

2. Battery cartridge

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

Makita AD02ZW Use and Care Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Makita AD02ZW