Makita 3700B Instruction Manual download pdf (Page 6)

The straight guide is effectively used for straight cuts

when chamfering or grooving.

Attach the guide plate to the straight guide with the bolt,

the wave washer, the flat washer and the wing nut.

Remove the chip deflector.

Attach the straight guide with the clamp screw (A).

Loosen the wing nut on the straight guide and adjust the

distance between the bit and the straight guide. At the

desired distance, tighten the wing nut securely.

When cutting, move the tool with the straight guide flush

with the side of the workpiece.

Circular work

Circular work may be accomplished if you assemble the

straight guide and guide plate as shown in the figures.

Min. and max. radius of circles to be cut (distance

between the center of circle and the center of bit) are as

follows:

Min.: 70 mm (2-3/4”)

Max.: 221 mm (8-11/16”)

For cutting circles between 70 mm (2-3/4”) and 121 mm

(4-3/4”) in radius.

For cutting circles between 121 mm (4-3/4”) and 221 mm

(8-11/16”) in radius.

NOTE:

• Circles between 172 mm (6-3/4”) and 186 mm (7-5/

16”) in radius cannot be cut using this guide.

Align the center hole in the straight guide with the center

of the circle to be cut. Drive a nail less than 6 mm (1/4”)

in diameter into the center hole to secure the straight

guide. Pivot the tool around the nail in clockwise direc-

tion.

Trimmer guide

Trimming, curved cuts in veneers for furniture and the like

can be done easily with the trimmer guide. The guide

roller rides the curve and assures a fine cut.

Install the trimmer guide on the tool base with the clamp

screw (A). Loosen the clamp screw (B) and adjust the

distance between the bit and the trimmer guide by turn-

ing the adjusting screw (1 mm (3/64”) per turn). At the

desired distance, tighten the clamp screw (B) to secure

the trimmer guide in place.

1. Bolt

2. Guide plate

3. Straight guide

4. Flat washer

5. Wave washer

6. Wing nut

1. Clamp screw

(A)

2. Straight guide

3. Wing nut

4. Base

1. Wing nut

2. Wave washer

3. Flat washer

4. Guide plate

5. Straight guide

6. Center hole

7. Bolt

001990

004559

001993

1. Wing nut

2. Wave washer

3. Flat washer

4. Guide plate

5. Straight guide

6. Center hole

7. Bolt

1. Nail

2. Center hole

3. Straight guide

001994

007110

007111

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Makita 3700B Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Makita 3700B