Makita 2414DB Instruction Manual download pdf (Page 6)

contacts the workpiece. Flip the vise nut to the right and

then turn the vise handle clockwise to securely retain the

workpiece.

CAUTION:

• Always set the vise nut to the right fully when

securing the workpiece. Failure to do so may result

in insufficient securing of the workpiece. This could

cause the workpiece to be ejected or cause a

dangerous breakage of the wheel.

When the cut-off wheel has worn down considerably, use

a spacer block of sturdy, non-flammable material behind

the workpiece as shown in the figure. You can more effi-

ciently utilize the worn wheel by using the mid point on

the periphery of the wheel to cut the workpiece.

When cutting workpieces over 65 mm (2-9/16”) wide at

an angle, attach a straight piece of wood (spacer) over

190 mm (7-1/2”) long x 45 mm (1-3/4”) wide to the guide

plate as shown in the figure. Attach this spacer with

screws through the holes in the guide plate.

If you use a spacer block which is slightly narrower than

the workpiece as shown in the figure, you can also utilize

the wheel economically.

Long workpieces must be supported by blocks of non-

flammable material on either side so that it will be level

with the base top.

OPERATION

Hold the handle firmly. Switch on the tool and wait until

the wheel attains full speed before lowering gently into

the cut. When the wheel contacts the workpiece, gradu-

ally bear down on the handle to perform the cut. When

the cut is completed, switch off the tool and WAIT UNTIL

THE WHEEL HAS COME TO A COMPLETE STOP

before returning the handle to the fully elevated position.

CAUTION:

• Proper handle pressure during cutting and

maximum cutting efficiency can be determined by

the amount of sparks that is produced while cutting.

Your pressure on the handle should be adjusted to

produce the maximum amount of sparks. Do not

force the cut by applying excessive pressure on the

handle. Reduced cutting efficiency, premature

wheel wear, as well as, possible damage to the tool,

cut-off wheel or workpiece may result.

Cutting capacity

Max. cutting capacity varies depending upon the cutting

angle and workpiece shape. Applicable wheel diameter:

355 mm (14”)

1. Spacer block

1. Guide plate

2. Straight piece of

wood (Spacer)

3. Over 45 mm

(1-3/4”) long

4. Over 65 mm

(2-9/16”) long

5. Over 190 mm

(7-1/2”) long

1. Diameter of

workpiece

2. Guide plate

3. Spacer block

4. Width of spacer

block

5. Vise

003764

003765

003766

1. Blocks

003767

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Makita 2414DB Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Makita 2414DB