Makita EA3500F Operator's Manual download pdf (Page 25)

8 10

Pull the chain (8) around the sprocket nose (10) of the guide

bar in the direction of the arrow.

Line up the holes in the sprocket guard (4) with the pins (11).

Turn the chain tensioning screw (B/3) to get the chain tension-

ing pin (12) aligned with the hole in the guide bar.

Push the sprocket guard (4) onto the pin (11).

Tightening the saw chain

Simultaneously push in hard on the sprocket guard quick ten-

sioner (2) and turn it clockwise to screw the sprocket guard on,

but do not yet tighten it.

Raise the tip of the guide bar slightly and turn the chain tensioner

(3) clockwise until the saw chain is ush against the bottom of

the guide bar (see circle).

Push the sprocket guard quick tensioner (2) in again and tight-

en by turning clockwise.

Release the sprocket guard chain tensioner until it turns freely,

then fold it in between protective ribs (15) as shown in the

illustration.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

No comments

Makita EA3500F Operator's Manual Page 25