Makita AN930H Use and Care Manual download pdf (Page 9)

Choose and use nails so that the penetration amount

into concrete ranges 10 mm (3/8") - 15 mm (5/8") by

referring to the table below.

30 mm(1-3/16")

35 mm(1-3/8")

45 mm(1-3/4")

50 mm(2")

Wood thickness Nail length Concrete range

50 mm(2")

65 mm(2-1/2")

10 mm(3/8") -15 mm(5/8")

013616

013615

CAUTION:

• Use this tool only for soft concrete built up not so

long before. Using on the hard concrete may

cause nail bending or nailing to insufficient depth.

• When the penetration amount into concrete comes

to more than 15 mm, nailing to the sufficient length

may not be obtained.

Cutting off the sheet

013454

CAUTION:

• Always disconnect the hose before cutting off the

sheet.

Tear off the output sheet in the direction of the arrow

when using the sheet collated nails.

Jammed nailer

013455

013456

CAUTION:

• Always disconnect the air hose and remove the

nails from the magazine before cleaning a jam.

When the nailer becomes jammed, do as follows:

After depressing the latch lever and open the door, open

the magazine cap and remove the nail coil. Insert a

small rod or the like into the ejection port and tap it with

a hammer to drive out the nail jamming from the

ejection port. Reset the nail coil and close the magazine

cap.

MAINTENANCE

CAUTION:

• Always disconnect the air hose from the tool

before attempting to perform inspection or

maintenance.

• Never use gasoline, benzine, thinner, alcohol or

the like. Discoloration, deformation or cracks may

result.

Drain tool

Remove the hose from the tool. Place the tool so that

the air fitting faces down to the floor. Drain as much as

possible.

Cleaning of tool

Iron dust that adhere to the magnet can be blown off by

using an air duster.

Cap

013459

When not in use, disconnect the hose. Then cap the air

fitting with the cap.

1. Cap

1. Nail length

2. Wood thickness

3. Concrete range

10 mm (3/8") -

15 mm (5/8")

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Makita AN930H Use and Care Manual Page 9

Comments to this Manuals