Makita AN930H Use and Care Manual download pdf (Page 6)

ASSEMBLY

CAUTION:

• Always disconnect the air hose before loading the

nailer.

Loading the nailer

CAUTION:

• Make sure that the coil support plate is set to the

correct step for used nails.

013444

Disconnect the air hose from the tool. Select nails

suitable for your work. Depress the latch lever and open

the door and magazine cap.

013445

Turn the adjust shaft so that the arrow with nail size

indicated on the change plate will point to the

corresponding graduation increment marked on the

magazine. If the tool is operated with the change plate

set to the wrong step, poor nail feed or malfunction of

the tool may result.

013446

Place the nail coil over the change plate. Uncoil enough

nails to reach the nail guide. Place the first nail in the

feeder and the second nail in the feed claw. Place other

uncoiled nails on feeder body. After checking to see that

the nail coil is set properly in the magazine, close the

magazine cap slowly and then close the door until it locks.

Connecting air hose

Slip the air socket of the air hose onto the air fitting on

the nailer. Be sure that the air socket locks firmly into

position when installed onto the air fitting. A hose

coupling must be installed on or near the tool in such a

way that the pressure reservoir will discharge at the

time the air supply coupling is disconnected.

Changing the trigger for intermittent nailing

CAUTION:

• Always disconnect the air hose and unload the

tool with nails before replacing the trigger.

• After the trigger replacement, always check the

tool operates properly before actual work. Do not

load the tool with any nails before checking the

function to avoid unexpected nailing.

013502

The trigger for continuous nailing is factory-installed. To

change the nailing mode to intermittent nailing, replace

the switch trigger with the one for intermittent nailing.

013551

1. Turn the lock lever to the "LOCK" position.

2. Push the pin securing the trigger from the

urethane washer side, and then remove the

urethane washer by fingers or flathead

screwdriver and so on. Pull the pin and remove it

from the hole in the housing.

Set the trigger assembly for intermittent nailing. Turn

the hinged part inward the trigger, and then set the

part to contact the rod of the valve in the housing.

4. Insert the pin to the hole and then secure it by

urethane washer.

5. Connect the air hose, and then check whether the

tool operates properly. Refer to the section

“Changing intermittent nailing mode”.

1. Urethane

washer

2. Pin

3. Lock lever

1. Trigger for

continuous

nailing

2. Silver part

3. Trigger for

intermittent

nailing

4. Black part

1. Door

2. Feed Claw

3. Driver channel

1. Adjust shaft

2. Arrow

3. Change plate

1. Latch lever

2. Door

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

Makita AN930H Use and Care Manual Page 6

Comments to this Manuals