Makita UT2204 User Manual download pdf (Page 4)

immediately after operation; they may be

extremely hot and could burn your skin.

8. Some material contains chemicals which may

be toxic. Take caution to prevent dust

inhalation and skin contact. Follow material

supplier safety data.

SAVE THESE INSTRUCTIONS.

WARNING:

MISUSE or failure to follow the safety rules stated in

this instruction manual may cause serious personal

injury.

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and

unplugged before adjusting or checking function on

the tool.

Switch action

Fig.1

CAUTION:

• Before plugging in the tool, always check to see

that the switch trigger actuates properly and

returns to the "OFF" position when released.

To start the tool, simply pull the switch trigger. Release

the switch trigger to stop.

For continuous operation, pull the switch trigger and

then push in the lock button.

To stop the tool from the locked position, pull the switch

trigger fully, then release it.

Indicator lamp

Fig.2

The green power-ON indicator lamp lights up when the

tool is plugged to the mains. If the indicator lamp is lit but

the tool does not start even if the tool is switched ON,

the carbon brushes may be worn out, or the motor or the

switch may be defective. If the indicator lamp does not

light up, the mains cord or the indicator lamp may be

defective. When the mains cord is defective, the tool

neither starts nor lights the indicator lamp. When the

indicator lamp is defective, the tool starts without the

indicator lamp lighting up.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Installing shaft

Fig.3

Tighten the shaft with hex. Nut into the shaft holder as

far as the hex nut comes into contact with the holder..

Hold the notch in the shaft holder with wrench 19 so that

it cannot revolve. With the notch held so, tighten the hex

nut with another wrench 19 in the direction of arrow

Fig.4

Installing mixing blades

Fig.5

Fig.6

Insert the mixing blade into the shaft and secure it with

the hex bolt.

At this time, position it so that the top end of the hex bolt

always fits to the flat surface on the shaft and tighten the

hex bolt with the provided wrench.

When installing the mixing blades at two different

positions (which is applicable only to the mixing blades

allowed to do so), mount and secure the two mixing

blades on the flat part of the shaft with the hex bolts so

that the same surface of blades faces each other as

shown in the figure.

Fig.7

Fig.8

OPERATION

Mixing

CAUTION:

• Do not use to mix flammable material such as paint

with thinner used as solvent. Failure to do so may

cause injury.

1. Hold the rear handle of the tool with one hand and

the grip with the other hand firmly, place the

mixing blade under material fully and turn on the

tool after making sure work site safety.

2. Move the mixing blade up and down during the

mixing operation so that whole part of material

can be mixed.

3. When finishing mixing, turn off the tool, make sure

that the mixing blade has come to a complete stop,

and then pull it out of the vessel.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection

or maintenance.

Replacing filter

Fig.9

Replace the filter regularly as the cooling efficiency of

the tool is reduced due to built-up dust or particles in

the filter.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Makita UT2204 User Manual Page 4

Comments to this Manuals

Related products and manuals for Mixers Makita UT2204