Makita XSL01Z Use and Care Manual download pdf (Page 9)

Loosen and remove the screw that secures the lever at

the rear of the tool. Remove the lever and install it again

so that it is slightly above the level. Secure the lever with

the screw firmly.

Switch action

011243

To prevent the switch trigger from being accidentally

pulled, a lock-off button is provided. To start the tool,

press in the lock-off button and pull the switch trigger.

Release the switch trigger to stop.

WARNING:

•

Before installing the battery cartridge on the tool,

always check to see that the switch trigger

actuates properly and returns to the "OFF"

position when released. Do not pull the switch

trigger hard without pressing in the lock-off button.

This can cause switch breakage.

Operating a tool

with a switch that does not actuate properly can lead to

loss of control and serious personal injury.

A hole is provided in the switch trigger for insertion of a

padlock to lock the tool off.

WARNING:

• Do not use a lock with a shank or cable any

smaller than 6.35 mm (1/4") in diameter. A

smaller shank or cable may not properly lock the

tool in the off position and unintentional operation

may occur resulting in serious personal injury.

•

NEVER use tool without a fully operative switch

trigger.

Any tool with an inoperative switch is

HIGHLY DANGEROUS and must be repaired before

further usage or serious personal injury may occur.

• For your safety, this tool is equipped with a lock-off

button which prevents the tool from unintended

starting. NEVER use the tool if it runs when you

simply pull the switch trigger without pressing the

lock-off button. A switch in need of repair may

result in unintentional operation and serious

personal injury. Return tool to a Makita service

center for proper repairs BEFORE further usage.

• NEVER defeat the lock-off button by taping down

or some other means. A switch with a defeated

lock-off button may result in unintentional operation

and serious personal injury.

Electric brake

This tool is equipped with an electric blade brake. If the

tool consistently fails to quickly stop the blade after the

switch trigger is released, have the tool serviced at a

Makita service center.

CAUTION:

• The blade brake system is not a substitute for

the blade guard. Never use tool without a

functioning blade guard. An unguarded blade

may result in serious personal injury.

ASSEMBLY

WARNING:

• Always be sure that the tool is switched off and

the battery cartridge is removed before

working on the tool. Failure to switch off and

remove the battery cartridge may result in serious

personal injury.

Hex wrench storage

012595

The hex wrench is stored as shown in the figure. When

the hex wrench is needed it can be pulled out of the

wrench holder. After using the hex wrench it can be

stored by returning it to the wrench holder.

Installing or removing saw blade

011300

WARNING:

• Always be sure that the tool is switched off and

the battery cartridge is removed before

installing or removing the blade. Accidental start

up of the tool may result in serious personal injury.

1. Stopper pin

1. Wrench holder

2. Hex wrench

1. Lock-off button

2. Switch trigger

3. Hole for padlock

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Comments to this Manuals

No comments

Makita XSL01Z Use and Care Manual Page 9

Comments to this Manuals

Related products and manuals for Mitre saws Makita XSL01Z