Makita XSL01Z Use and Care Manual download pdf (Page 18)

Over 15mm (5/8") Over 420mm (16-1/2")

50mm-60mm

(2"-2-3/8")

27mm (1-1/16")

85mm

(3-3/8")

70mm

(2-3/4")

85mm

(3-3/8")

70mm

(2-3/4")

002206

CAUTION:

• Use the straight wood of even thickness as the

wood facing.

WARNING:

• Use screws to attach the wood facing to the

guide fence. The screws should be installed

so that the screw heads are below the surface

of the wood facing so that they will not

interfere with the positioning of the material

being cut. Misalignment of the material being cut

can case unexpected movement during the cutting

operation which may result in a loss of control and

serious personal injury.

NOTICE:

• When the wood facing is attached, do not turn the

turn base with the handle lowered. The blade

and/or the wood facing will be damaged.

8. Cutting repetitive lengths

001846

When cutting several pieces of stock to the same

length, ranging from 220 mm (8-5/8") to 385 mm

(15-1/8"), use of the set plate (optional accessory)

will facilitate more efficient operation. Install the set

plate on the holder (optional accessory) as shown

in the figure.

Align the cutting line on your workpiece with either

the left or right side of the groove in the kerf board,

and while holding the workpiece from moving,

move the set plate flush against the end of the

workpiece. Then secure the set plate with the

screw. When the set plate is not used, loosen the

screw and turn the set plate out of the way.

NOTE:

• Use of the holder-rod assembly (optional

accessory) allows cutting repetitive lengths up to

2,200 mm (7.2ft) approximately.

9. Groove cutting

001563

A dado type cut can be made by proceeding as

follows:

Adjust the lower limit position of the blade using

the adjusting screw and the stopper arm to limit the

cutting depth of the blade. Refer to "Stopper arm"

section described on previously.

After adjusting the lower limit position of the blade,

cut parallel grooves across the width of the

workpiece using a slide (push) cut as shown in the

figure. Then remove the workpiece material

between the grooves with a chisel.

WARNING:

• Do not attempt to perform this type of cut by

using a wider type blade or dado blade.

Attempting to make a groove cut with a wider blade

or dado blade could lead to unexpected cutting

results and kickback which may result in serious

personal injury.

• Be sure to return the stopper arm to the

original position when performing other than

groove cutting. Attempting to make cuts with the

stopper arm in the incorrect position could lead to

unexpected cutting results and kickback which

may result in serious personal injury.

Carrying tool

011300

1. Stopper pin

1. Cut grooves with

blade

1. Set plate

2. Holder

3. Screw

1. Holes

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Comments to this Manuals

No comments

Makita XSL01Z Use and Care Manual Page 18

Comments to this Manuals

Related products and manuals for Mitre saws Makita XSL01Z