Makita LS0815F Use and Care Manual download pdf (Page 20)

2. Bevel angle

(1) 0° bevel angle

014299

Push the carriage toward the guide fence

and tighten the locking screw to secure the

carriage. Lower the handle fully and lock it in

the lowered position by pushing in the

stopper pin. Loosen the lever at the rear of

the tool.

014295

Turn the hex bolt on the right side of the arm

two or three revolutions counterclockwise to

tilt the blade to the right.

001819

Carefully square the side of the blade with

the top surface of the turn base using the

triangular rule, try-square, etc. by turning the

hex bolt on the right side of the arm

clockwise. Then tighten the lever securely.

014286

Make sure that the pointer on the arm point to 0°

on the bevel scale on the arm holder. If they do

not point to 0°, loosen the screw which secure

the pointer and adjust it so that it will point to 0°.

(2) 45° bevel angle

014296

Adjust the 45° bevel angle only after performing

0° bevel angle adjustment. To adjust left 45° bevel

angle, loosen the lever and tilt the blade to the left

fully. Make sure that the pointer on the arm points

to 45° on the bevel scale on the arm holder. If the

pointer does not point to 45°, turn the 45° bevel

angle adjusting bolt on the right side of the arm

holder until the pointer points to 45°.

To adjust the right 5° bevel angle, perform

the same procedure as that described above.

Replacing carbon brushes

007834

Remove and check the carbon brushes regularly.

Replace when they wear down to 3 mm in length. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps.

1. Right 5 ﾟ bevel

angle adjusting

bolt

2. Left 45 ﾟ bevel

angle adjusting

bolt

1. Screw

2. Pointer

3. Bevel scale

1. Triangular rule

2. Saw blade

3. Top surface of

turn table

1. 0 ﾟ adjusting bolt

2. Left 45 ﾟ bevel

angle adjusting

bolt

1. Lever

2. Arm

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Comments to this Manuals

No comments

Makita LS0815F Use and Care Manual Page 20

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS0815F