Makita 2704 Datasheet download pdf (Page 12)

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection

or maintenance.

Cleaning

Clean out sawdust and chips from time to time. Carefully

clean the blade guard and moving parts inside the table

saw.

Lubrication

To keep the table saw in tip-top running condition, and to

assure maximum service life, oil or grease the moving

parts and rotating parts from time to time.

Lubrication places:

• Threaded shaft to elevate the blade

• Hinge to rotate the frame

• Elevation guide shafts on motor

• Gear to elevate the blade

• Guide rails for the rip fence

• Shaft of the sub table (R) locking levers

• Sliding part of the sub table (R)

Replacing carbon brushes

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. To

replace the carbon brushes, remove the blade guard and

blade and then loosen the lock lever, tilt the saw head

and secure it at 45° bevel angle. Carefully lay the tool on

itself backward. Then loosen the brush holder cap.

Remove the worn carbon brushes, insert the new ones

and secure the brush holder caps.

After replacing brushes, plug in the tool and break in

brushes by running tool with no load for about 10 min-

utes. Then check the tool while running and electric

brake operation when releasing the switch trigger. If elec-

tric brake is not working well, ask your local Makita serv-

ice center for repair.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be per-

formed by Makita Authorized or Factory Service Centers,

always using Makita replacement parts.

ACCESSORIES

CAUTION:

• These accessories or attachments are

recommended for use with your Makita tool

specified in this manual. The use of any other

accessories or attachments might present a risk of

injury to persons. Only use accessory or

attachment for its stated purpose.

If you need any assistance for more details regarding

these accessories, ask your local Makita service center.

Dado head set (Part No. 191794-9)

A dado is cutting a rabbet or a wide groove into the work-

piece. The dado head set consists of two outside cutters,

five inside cutters and paper washers.

• Outside cutters: 6”diameter, 1/8” thick, 5/8”arbor

hole, 2 pcs.

• Inside cutters: 6”diameter, 1/8”thick, 5/8”arbor hole,

4 pcs.

• Inside cutter: 6”diameter, 1/16”thick, 5/8”arbor hole,

1 pc.

• Paper washers: 5/8”arbor hole, 6 pcs.

Various combinations of these cutters are used to cut

grooves from 1/8” to 13/16” for use in making joints, ten-

oning, grooving, etc.

1. Limit mark

001145

1. Brush holder

cap

2. Screwdriver

1. Inside cutter

2. Outside cutter

006173

006174

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comments to this Manuals

No comments

Makita 2704 Datasheet Page 12

Comments to this Manuals

Related products and manuals for Mitre saws Makita 2704