Makita HB500 Specifications download pdf (Page 6)

• To power up the maChine, press and release

the red button Fig. 5

• To energiSe the magnet, press and release

the yellow button - the yellow LED will light

Fig. 6.

RECHECK the pilot is still centred on the hole

position - energising the magnet can sometimes

cause the unit to move slightly from the centre

mark, reposition if necessary.

• The magnet will hold on all ferrous materials

from a minimum of 6mm (1/4”) thickness.

STARTING THE CUT

•

alwayS lower the safety guard.

• Start the motor by pressing and releasing

the green button - the green LED will light

Fig. 7.

• Wind the cutter gently down to the surface

of the work and apply light pressure until

the cutter has made the initial groove in the

surface. Increase the pressure until the motor

is loaded Fig. 8.

• Maintain steady pressure throughout the rest

of the cut. Too much pressure will not speed

the cut, it will reduce the life of the cutter and

may cause damage to the motor. If the shavings

become blue add more oil.

startinG the cut

N.B. Safety strap has been omitted from the photo’s for clarity.

Fig. 5

Fig. 6

Fig. 7

Fig. 8

• to stop the motor,

PRESS & RELEASE GREEN BUTTON.

• If the cutter jams in the workpiece,

Stop the

motor

and gently raise the cutter out of the

workpiece before re-starting.

• If the power is interrupted during the cut,

the machine must be reset before the motor

will restart.

• At the end of the cut, the slug will be ejected.

Withdraw the cutter from the work piece and

stop the motor.

• To disengage the magnet, press and release

the yellow button - the magnet will not

disengage immediately, there will be a 3 second

delay before the magnet disengages along with

a continuous beep.

INCORRECT START UP OR SHUT DOWN

SEQUENCE:-

• A single beep will be heard for all operations

carried out in the correct sequence. A

continuous beep will sound for any incorrect

sequence.

• Neither drill nor magnet can be operated until

red power button is activated.

• When the red power button is activated, the

motor will not run until the magnet is activated.

power up the maChine

energiSe the magnet

Start the motor

Start the Cut

N.B. Safety strap has been omitted from the photo’s for clarity.

1 2 3 4 5 6 7 8 9 10 11 ... 30 31

Comments to this Manuals

No comments

Makita HB500 Specifications Page 6

Comments to this Manuals