Makita BUH650 Instruction Manual download pdf (Page 7)

Handle mounting positions

011148

The handle can be rotated to either 90° left or right and

mounted either 45°or 90°position to fit your work needs.

First, pull the knob and rotate the handle clockwise or

counterclockwise in the direction of arrow as shown in

the figure. The handle will be locked in 45°position. The

pull the knob and rotate more. The handle will be locked

in 90°position.

CAUTION:

• Always make sure that the handle is locked in the

desired position before operation.

Switch action

CAUTION:

• Before inserting the battery cartridge into the tool,

always check to see that the switch trigger

actuates properly and returns to the "OFF"

position when released.

011163

For your safety, this tool is equipped with a dual

switching system. To turn on the tool, press triggers A

and B. Release either one of the two pressed triggers to

turn off. The sequence of switching is unimportant as

the tool only starts when both switches are activated.

Speed change

011233

The strokes per minute can be adjusted just by turning

the adjusting dial. This can be done even while the tool

is running. The dial is marked 1 (lowest speed) to 6 (full

speed).

Refer to the table below for the relationship between the

number settings on the adjusting dial and the strokes

per minute.

Number on adjusting dial Strokes per minute (min )

-1

1,800

1,750

1,650

1,500

1,300

1,000

011264

CAUTION:

• The speed adjusting dial can be turned only as far

as 6 and back to 1. Do not force it past 6 or 1, or

the speed adjusting function may no longer work.

• The strokes per minute vary by the conditions of

battery cartridge and shear blades.

Battery protection system

Lithium-ion batteries are equipped with a protection

system. This system automatically cuts off power to the

tool to extend battery life.

The tool will automatically stop during operation if the

tool and/or battery are placed under one of the following

conditions:

• Overloaded:

The tool is operated in a manner that causes

it to draw an abnormally high current.

In this situation, release the switch trigger on

the tool and stop the application that caused

the tool to become overloaded. Then pull the

switch trigger again to restart.

If the tool does not start, the battery is

overheated. In this situation, let the battery

cool before pulling the switch trigger again.

1. Adjusting dial

1. Switch trigger B

2. Switch trigger A

1. Housing

2. Knob

3. Handle

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Makita BUH650 Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Cordless hedge trimmers Makita BUH650