Makita 9067DB User Manual download pdf (Page 10)

OPERATION

WARNING:

• It should never be necessary to force the tool. The

weight of the tool applies adequate pressure. Forcing

and excessive pressure could cause dangerous wheel

breakage.

• ALWAYS replace wheel if tool is dropped while grinding.

• NEVER bang or hit grinding disc or wheel onto work.

• Avoid bouncing and snagging the wheel, especially

when working corners, sharp edges etc. This can cause

loss of control and kickback.

• NEVER use tool with wood cutting blades and other

sawblades. Such blades when used on a grinder

frequently kick and cause loss of control leading to

personal injury.

CAUTION:

• After operation, always switch off the tool and wait until

the wheel has come to a complete stop before putting

the tool down.

Grinding and sanding operation

ALWAYS hold the tool firmly with one hand on rear handle

and the other on the side handle. Turn the tool on and then

apply the wheel or disc to the workpiece.

In general, keep the edge of the wheel or disc at an angle of

about 15 degrees to the workpiece surface.

During the break-in period with a new wheel, do not work the

grinder in the B direction or it will cut into the workpiece.

Once the edge of the wheel has been rounded off by use, the

wheel may be worked in both A and B direction.

Operation with wire cup brush (For 9067L only)

(optional accessory)

CAUTION:

• Check operation of brush by running tool with no load,

insuring that no one is in front of or in line with brush.

• Do not use brush that is damaged, or which is out of

balance. Use of damaged brush could increase potential

for injury from contact with broken brush wires.

15˚

001127

1. Wire cup brush

2. Urethane washer

001141

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Makita 9067DB User Manual Page 10