Makita 6940D User Manual download pdf (Page 10)

Installing or removing driver bit or socket bit

Use only the driver bit or socket bit shown in the figure. Do

not use any other driver bit or socket bit.

To install the bit, pull the sleeve in the direction of the arrow

and insert the bit into the sleeve as far as it will go. Then

release the sleeve to secure the bit.

To remove the bit, pull the sleeve in the direction of the arrow

and pull the bit out firmly.

NOTE:

• If the bit is not inserted deep enough into the sleeve, the

sleeve will not return to its original position and the bit

will not be secured. In this case, try re-inserting the bit

according to the instructions above.

Adjusting the angle head

The angle head can be adjusted 360° (8 positions in 45-

degree increments). To adjust it, loosen the hex bolt and

remove the angle head.

Adjust the angle head to the desired position and reinstall it

so that the teeth on the housing will match up with the

grooves in the angle head. Then tighten the hex bolt to

secure the angle head.

12 mm

(15/32”)

9 mm

(3/8”)

001266

1. Bit

2. Sleeve

002824

1. Hex bolt

2. Angle head

1. Groove

2. Tooth

002826

002827

1 ... 9 10 11 ... 20

No comments

Makita 6940D User Manual Page 10