Makita 6176D User Manual download pdf (Page 10)

• A stuck bit can be removed simply by setting the

reversing switch to reverse rotation in order to back out.

However, the tool may back out abruptly if you do not

hold it firmly.

• Always secure small workpieces in a vise or similar hold-

down device.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off before

attempting to perform inspection or maintenance.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.

DISPOSING OF TOOL

A Ni-Cd battery is built into the handle of the tool. Always

remove it before disposing of the tool.

Removing built-in battery

CAUTION:

• Never remove the built-in battery from the tool except

when disposing of the tool. The battery will be damaged

or a battery short-circuit could result.

To remove the cover, push it in the direction of the arrow

while pressing down on the “OPEN” portion of the cover.

Withdraw the built-in battery halfway. Disconnect the two

lead wires from the battery by pulling them from the battery

terminals. Then withdraw the battery completely.

To prevent a battery short-circuit, tape the battery terminals

or put the battery into a plastics bag. (Note: Never put two or

more batteries into one plastics bag. Battery short-circuit

may result.)

CAUTION:

• Never incinerate the battery even if it is severely

damaged or is completely worn out. It can explode in a

fire or toxic materials can leak out of it.

1. Cover

002144

1. Battery terminal

2. Lead wire

3. Battery

002145

1 ... 9 10 11 12 13 14 15 16

Yvonna 29 Aug 2024 | 08:55:58

How do you remove the terminals from the 6176d battery without breaking it?

Makita 6176D User Manual Page 10